Water & Wastewater Treatment
Reliable voltage for pump stations and treatment plant control systems built to run continuously.
Water and wastewater treatment plants run on pumps, blowers, aerators and dosing systems that mostly can’t be switched off without consequence, whether that’s a supply interruption downstream or a process step (aeration, dosing) falling out of the window it’s supposed to run in. These sites are also often on the periphery of the grid rather than close to a substation, which tends to mean a wider and less predictable voltage swing than a facility closer to the source. Automation and control panels running the plant see that instability directly, on top of whatever it does to the motors.
Continuous Pump Operation
Corrects voltage ahead of pump and blower motors, reducing trips tied to supply dips and surges.
Three-Phase Correction
Corrects each phase independently, addressing the imbalance common on feeders serving remote or peripheral sites.
Control Panel Protection
Stabilizes the supply feeding automation and dosing control panels, not just the motors.
Wide Input Voltage Range
Built for the wider voltage swings typical of feeders further from the substation.
Continuous Duty Rated
Built for round-the-clock operation, matching how a treatment plant actually runs.
Sized to Plant Load
Specified against the plant's total connected load rather than any single pump or blower.